Cellink neo installation manual

Cellink NEO Battery Pack | Smart Power Bank for Dash Cams | Supplies up to 24 Hrs (2Channel) and up to 45 Hrs (1Channel) of Battery Life to Your Dash Cam (Spliced Ver. for Thinkware Dash Cams) 4.0 out of 5 stars 40 Cellink NEO 6, Dash Cam Power Source,blackvue, DR750s, DR900s, Car Power Pack, Dash camera Chargerm Blackvue UK, Cellink Neo Range +44 (0)1159 599 995 sales@blackvuehd.co.uk. NEO 6 can be powered from any cigarette lighter socket without the need for installation, or alternatively hardwired out-of-sight in the glovebox or boot. QVIA HD - (TTW) Unit 15 Lloyd Street, Nottingham, NG5 4BX. Registered in England. Company Number: 08903207 VAT no: GB 237 8078 80 1. Connected device (connected model) 2. Battery capacity (%) 3. Battery status (charge / discharge status) 4. Charge / discharge time 5. Battery temperature (℃) 6. Input / output voltage and Hardwired out-of-sight in the glovebox or boot. It charges to capacity 40/50 minutes when hardwired. The NEO 9 package includes all cabling for hardware installation. SPECIFICATIONS. Battery Cell Type : LiFePo4 (Lithium Iron Phosphate) Colour / Size / Weight : Black / 157mm (W) x 243mm (L) x 39.5mm. (H) / 1.8kg. The ultimate supplementary power source for your dash cam . The largest capacity battery pack in the EGEN Cellink range, the Cellink NEO 9 is specially designed to provide independent power to your dash cam device, delivering extended Parking Mode operation and increased recording time, without ever having to draw power from the vehicle's battery. Meet the Cellink NEO, the next generation of Cellink Batteries. When you are ready to install your dash cam, check out our general battery pack installation guide and the Cellink NEO battery pack installation guide. There are more than one method to install your battery pack; either use a hardwiring kit or a traditional 12V cigarette The Cellink NEO6 is charged by driving your vehicle and is fully charged within 1 hour and 20 minutes of driving or 45 minutes if you have the battery set to high and wired into a 9amp circuit. The Cellink NEO6 can be easily installed into any vehicle as you are able to hard-wire into the vehicle. 2 x charging input cables to charge the NEO - either charge the NEO via the included hardwire cable or the 12V cigarette lighter cable (male adaptor) 2 x output cables for the Dash Cam connection - included is a female cig lighter socket & a 3-wire cable for Dash Cams with hardwire cables Manual Adhesive velcro strips Cellink NEO 8+ comes with the default hardwiring kit. We recommend NEO 8+ to be installed by our authorised dealers for safe installation since it requires connection to fuse box for rapid charging. Installers must comply with our safety guidelines, use the original power cables and fuse kits as to avoid any damage to the product and car. Avoid Wear and Tear. With a Hardwired Dash Cam, the constant discharge on the battery over a long period of time can cause wear and tear. The iVolt Mini Battery Pack only draws power to charge when you are driving the vehicle, which prevents damage to the vehicle's battery over time. With the ignition off, the Dash Cam relies solely on the The Cellink NEO will be hardwired with add-a-fuse to an accessory fuse in the fuse box. This way it is faster charging for the Cellink NEO (a 40 minute drive to fully charge). The Cellink will also run both dash cams in buffered Parking Mode. Supposed to run for 25 hours using 2 cams.