Electric utility safety manual

Alliant Energy's electric and gas service manuals supply essential information to customers, employees, architects, engineers, contractors, inspectors, and others concerned with the planning and construction of electric and gas service installations in our utility service areas. The information is provided in printer-friendly Adobe Acrobat PDF Electric Service Manual Section 2 - Electric Services 9 (10/18/2018) • It is recommended that overhead service conductors be about 16-18 feet above ground at point of attachment on the building. Where structure or clearance does not permit this, a maximum of 28 feet or a minimum of 13 feet (including drip loop) shall be maintained. The purpose of this handbook is to identify electrical safety hazards and present ways to minimize or avoid their consequences. It is a guide for improving electrical safety and contains information about governmental regulations, industry-accepted standards and work practices. It presents ways to meet the standards and reduce the hazards. Electrical safety is a general practice of workers who are exposed to handling and maintaining electrically powered equipment. It is a set of guidelines they follow to mitigate electrical hazards and prevent its dangerous effects in case of an incident. Unable to adhere to electrical safety can lead to accidents, near misses, or even fatalities. Turn the key to OFF position, release safety belt, remove the key and take it with you. g) FUELING THE VEHICLE: i. Turn switch to the off position and allow 15 minutes for engine to cool before fueling. ii. Never pour gasoline into the fuel tank when the engine is hot or while it is running. iii. the Basic 69 page Manual and will include the below Utility Contractor Safety Program ManualChapters: All the above Chapters will be included in Your Safety Program Manual! +150 Pages! Your Manual will already be page numbered and it will have Your Business Name Throughout the Document! Yours for only $249.95 Need to add This manual may require different electrical equipment than was previously used in Pacific Power and Rocky Mountain Power service areas. This manual complies with the National Electric Safety Code (NESC), the National Electrical Code (NEC), and the Electric Utility Service Equipment Requirements Committee (EUSERC). This Safety Manual P-1 060 is directed to operators, electricians and supervisors who perform and supervise operations and maintenance work. The manual is divided into four chapters.Chapter one covers definitions and general safety practices. Chapter two deals with switching, tagging, testing of circuits Utility Customer Services 300 S. Adams St. Box A2 Tallahassee, FL 32301 • By Fax: Download and completely fill out the New S ervice Form or Transfer Service Form and fax it to Utility Customer Services at (850) 891-0901. Electrical Safety Procedure Document Ref No. TPSMS/CSP/ELEC/010 Rev 01 Date of Issue: 01/01/2016 Note: Uncontrolled once printed Page 7 of 33 6. 4 TESTING FOR ABSENCE OF VOLTAGE 6. 4.1 All circuits are considered energized until verified dead by testing it with appropriate instruments such as non-range selectable voltage indicators Bookshare - Accessible Books for Individuals with Print Disabilities 4 Disaster Management, Electrical safety procedures and accident prevention National Power Training Institute 2. 3 CEA (Safety Requirements for Construction, Operation & Maintenance of 4 Disaster Management, Electrical