Scxi 1520 manual

The SCXI-1314 (Part Number: 777687-14) is created for use with the SCXI-1520 universal strain/bridge module. This combination allows the user to easily link strain gauges via screw terminals. The 88 screw terminals on this Terminal Block are configured in eight groups, with 11 screw terminals in each group. Solved: I have a SCXI-1000 chassis with scxi-1520 module and scxi-1314 terminal block and was wondering how to perform a calibration on it? Do I need. Return to Home Page; Toggle navigation; There are manual calibration procedures available online here for many of our products. Here are the calibration procedures for the 1314 and 1520. This content provides support for older products and technology, so you may notice outdated links or obsolete information about operating systems or other relevant products. This manual describes the electrical and mechanical aspects of the SCXI-1121 and contains information concerning its operation and programming. National Instruments SCXI-1600 Data Acquisition Module. Featured with a 16-bit ADC, the NI SCXI-1600 (Part Number: 776572-1600) is a USB Data Acquisition Module (DAQ) for SCXI. This module is a full-featured control and data module for SCXI digital I/O, switching, analog input, and analog output modules. The user can install the SCXI-1600 in a Product Manuals: SCXI-1520 User Manual Product Manuals: SCXI-1180/1181 User Manual SCXI-1349およびSCXI-1346の50ピンコネクタの対応 パラレルモードに対応しているSCXIモジュールはどれですか SCXI-1520モジュールを使用してアナログ入力電圧を計測できますか 添付: Refer to the SCXI-1102/B/C User Manual for more information on the routing of module output. calhandle in is a reference to the calibration session that you created using the DAQmx Initialize External Calibration VI. Sets an SCXI-1520 module to the specified gain value for calibration. This VI disables the sample-and-hold circuitry on the For a complete description of the use and operation of the SCXI-1520 module, refer to the SCXI-1520 User Manual. What You Need to Get Started To install and use your SCXI-1314 terminal block, you need the following items: SCXI-1314 terminal block SCXI-1314 Universal Strain Terminal Block Installation Guide The 1314 manual clearly indicates that the shunt cal resistors are in sockets so that the user can select a desired shunt calibration. Using the 11,800ohm resistor produces a calibration point at 5000 micro-strain. I used "Cont Acq Strain Samples (with Calibration) - SCXI 1521.vi" as a template to write the VI attached in the original post. But The SCXI-1530 (Part Number: 777966-30) is a signal conditioning module designed for integrated electronic piezoelectric (IEPE) accelerometers and microphones. This module can work with accelerometer conditioning modules that incorporate programmable current, gain, and filter configurations on every channel.