Vista 100 programming manual

ademco-vista-100-alarm-system-manual.pdf (145 views) Ademco VISTA 100 Alarm Manual | Find, download and program your existing Ademco VISTA 100 security alarm system with the manufacturer Ademco VISTA 100 alarm manual, Ademco VISTA 100 alarm installation manual, Ademco VISTA 100 alarm operation manual, Ademco VISTA 100 alarm owner manual, Ademco - 3 - DATA FIELD PROGRAMMING FORM Where noted, certain fields have special settings when used with the VISTA-10PSIA (indicated by heavy borders and reverse type throughout for easy identification). SIA Guidelines: Notes in certain data fields give instructions for programming the VISTA-10P for False Alarm Reduction. NOTE: Entry of a number other than one specified will give unpredictable Place you Vista 100 Phone on a table or hang it on a wall. Then fit the Discovery Card over the keys on the phone When you have power: NOTE: presso to program a pause into a memory key when entering numbers. For example, to enter the number 555-1440: 1. Press Ó. 2. Press the memory key where you want to save the number. NOTE: All references in this manual for number of zones, number of user codes, number of access cards, and the event log capacity, use the VISTA-250FBP's features. The following table lists the differences between the VISTA- If you need further information about specific programming options, see the VISTA- This system can record various events in a history log (VISTA-20P = 100 events; VISTA-15P = 50 events). At any time, the downloader operator can then upload the log and view or print out all or selected categories of the log, or can clear the log. • To program a device for manual activation (user code + [#] [7] / [#] [8] + 2-digit device VISTA-32FB 4 2.0 WAVIS32FB-12 VISTA-128B 8 2.0 WAVIS128B-12 VISTA-128FB 8 3.0 WAVIS128FB-13 FA1600C 8 7.0 WAVIS150FA-17 You may obtain the software revision level of the alarm panel by entering the program mode and then entering #92 on the keypad. The second line of the keypad displays the software revision level (without the decimal point). Local programming requires the use of a 2-line Alpha keypad connected to the keypad terminals on the control. Field Function Programmed Values [ ] = Default Value SYSTEM SETUP ( 20- 30) 20 INSTALLER CODE ÊÊÊÊ|ÊÊÊÊÊ|ÊÊÊÊÊ|ÊÊÊÊ [4 1 1 2] Enter 4 digits, 0-9 22 RF SYSTEM ÊÊÊÊ [0] 0 = none; 1 = 5800 (5881/5882) n6019-2v1 1/98 vista-100 commercial fire and burglary partitioned security system with scheduling installation instructions and programming guide Exits programming mode and prevents re-entry by: Installer Code + 8 + 0 + 0. To reenter programming mode, the system must be powered down, then powered up. Then use method A above. See field *88 for other *98 Program mode lockout options. Exit Program Mode Press 99. Exits programming mode and allows re-entry by: Installer Code + 8 + 0 + 0 or 1625 Surveyor Avenue • Simi Valley, CA 93063 • (805) 527-0987 • (800) 766-VISTA (8478) FAX: (888) 670-VISTA (8478) • email@vistapro.com • vistapro.com Vista Professional Outdoor Lighting reserves the right to modify the design and/or construction of the fixture shown without further notification. INSTALLATION & OPERATORS GUIDE programming procedure is included, followed by a list of program fields with the corresponding program group they belong to (system-wide, partition-specific, scheduling, etc.). Two program forms are included. One contains all the programming fields, and the other contains the partiti